Axxess-interface ASWC Manuel d'utilisateur télécharger pdf (Page 6)

Section 1: Installation

Onceyouhavecollectedorprintedouttheinformationsheetonyour

particularvehiclefromtheAxxesswebsite(www.axxessinterface.com)

you’rereadytoinstalltheASWC.

Installing the ASWC

1) ConnecttheBlackwireoftheASWCtoground.Youmayusethe

samegroundingpointastheaftermarketradio.

2) ConnecttheRedwireoftheASWCtoa12-voltaccessorywire,one

thatturns“on”and“off”withtheignitionkey.

3) LocatethecorrectSWCwire(s)inthevehicle’sradioprimaryor

secondaryharnessasdescribedinthevehicleinformationsheet

foundontheAxxesswebsite.Connectthecorrectwirecolor(s)from

theASWCtothesteeringwheelcontrolwire(s)inthevehicle.

Note: Metra recommends that the wire(s) are soldered for the

best and most secure connection. T-Taps or scotch locks are not

recommended due to the higher chance of an intermitted connection

or change in resistive values.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Axxess-interface ASWC Manuel d'utilisateur Page 6