Axxess-interface OESWC-LAN29-STK Manuel d'utilisateur télécharger pdf (Page 3)

ASWCSTALK ASSEMBLY

1. Remove and drill a 3/8 hole in the steering wheel shroud.

2. Select desired length rod and thread a 3/8 hex nut on to the shorter

threaded section.

3. Run the four wires from the ASWCSTALK through the rod of choice

and screw it into the ASWCSTALK

4. Take the twist on cover, run the wires through, and twist the cap on to

the ASWCSTALK making sure to align the notches on the cover.

5. Screw the DECORATIVE NUT to the end of the rod with the smaller

end facing the ASWCSTALK

6. Select the desired angle mount and put it on to the rod with the angle

facing away from the ASWCSTALK.

7. Run wires through the steering wheel shroud and insert rod through

the shroud.

8. Secure the ASWCSTALK with the supplied 3/8 nut. (Do not over

tighten)

9. Run wires to where the ASWCSTALK interface will be.

1 2 3 4 5 6 7 8

Pas de commentaire

Axxess-interface OESWC-LAN29-STK Manuel d'utilisateur Page 3